How to Replace Car Speakers in the Instrument Panel on 2000 Dodge Stratus?

The first step in replacing the instrument panel speaker is to break the remote connection from the battery negative cable. Gently use a trim tool or a suitable object to get underneath and lift both left and right A-pillar trim moldings. After that, take out the screw on the right side, lift each side edge of the top cover to unlock it from the clips, use a trim stick to lift the back and gently pull it to the rear so the front clips clear. To replace the speaker, remove the two screws holding it, raise the speaker from the case and take the wire connector apart. Reverse the instructions to remove when installing.

OEM 2000 Dodge Stratus Car Speakers

Audio Speakers

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Car Speakers found

View related parts
2000 Dodge Stratus Instrument Panel Speaker, Rear Part Number: 4760916AA
Product Specifications
- Other Name: Speaker Rear 6X9; Rear Driver Speaker; Speaker
- Position: Rear
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4760916AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2000 Dodge Stratus Submodels:
- Base, ES, SE | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS, 6 Cyl 2.5 L GAS
View related parts
2000 Dodge Stratus Speaker Part Number: 4608243
Product Specifications
- Other Name: Speaker, 6X6 Base; Speaker, 6X9 Base; Speaker Rear 6X9
- Item Weight: 2.30 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4608243
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2000 Dodge Stratus Submodels:
- Base, ES, SE | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L GAS, 6 Cyl 2.5 L GAS

2000 Dodge Stratus Car Speakers Parts and Q&A

Q: How to Replace Car Speakers in the Instrument Panel on 2000 Dodge Stratus?
A: The first step in replacing the instrument panel speaker is to break the remote connection from the battery negative cable. Gently use a trim tool or a suitable object to get underneath and lift both left and right A-pillar trim moldings. After that, take out the screw on the right side, lift each side edge of the top cover to unlock it from the clips, use a trim stick to lift the back and gently pull it to the rear so the front clips clear. To replace the speaker, remove the two screws holding it, raise the speaker from the case and take the wire connector apart. Reverse the instructions to remove when installing.