How to Safely Remove and Install the Spoiler on the JR-41 Sedan and JR-27 Convertible on 2006 Chrysler Sebring?

To remove the spoiler from the JR-41 (Sedan), remove the decklid cover, take off 4 nuts, and remove the spoiler. For the JR-27 (Convertible) similar steps, using a trim stick to release tape. Clean the area then reinstall the spoolers, tightening nuts to specified torque.

OEM 2006 Chrysler Sebring Spoiler

Spoiler Wing

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Spoilers found

View related parts
2006 Chrysler Sebring Spoiler, Rear Part Number: WF68TZZAC
Product Specifications
- Other Name: Spoiler - Rear Air Dam; Spoiler, Rear; Spoiler Rear Air Dam
- Position: Rear
- Replaces: WF68TZZAB
- Item Weight: 9.20 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: WF68TZZAC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Chrysler Sebring Submodels:
- Base, LX, LXi, Limited, TSi, Touring | 4 Cyl 2.4 L GAS, 6 Cyl 2.7 L FLEX, 6 Cyl 2.7 L GAS, 6 Cyl 3.0 L GAS
View related parts
2006 Chrysler Sebring Spoiler Assembly, Rear Part Number: 82207638
Product Specifications
- Other Name: Spoiler - Decklid; Spoiler, Rear; Spoiler Kit Decklid
- Position: Rear
- Item Weight: 7.50 Pounds
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 82207638
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2006 Chrysler Sebring Submodels:
- Base, GTC, LX, LXi, Limited, Touring | 4 Cyl 2.4 L GAS, 6 Cyl 2.7 L FLEX, 6 Cyl 2.7 L GAS

2006 Chrysler Sebring Spoiler Parts and Q&A

Q: How to Safely Remove and Install the Spoiler on the JR-41 Sedan and JR-27 Convertible on 2006 Chrysler Sebring?
A: To remove the spoiler from the JR-41 (Sedan), remove the decklid cover, take off 4 nuts, and remove the spoiler. For the JR-27 (Convertible) similar steps, using a trim stick to release tape. Clean the area then reinstall the spoolers, tightening nuts to specified torque.