How to Remove the Cruise Control Servo Assembly on 2007 Jeep Grand Cherokee?

First disconnect the negative power cable at the battery before handling the speed control servo assembly. After that, remove the vacuum line and the power wire from the servo. Take out the servo mounting bolt and cut the servo cable right at the throttle body. After that, take out the two nuts that hold the servo cable sleeve in place on the bracket. Pull back the speed control cable sleeve and servo out of their mounts to access and remove the cable locking clip. Lastly, pull the servo out from the bracket, being sure to keep a note of which side of the servo is facing up during your removal.

OEM 2007 Jeep Grand Cherokee Cruise Control Servo

Cruise Control Servo Speed

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Cruise Control Servo found

View related parts
2007 Jeep Grand Cherokee Cruise Servo Part Number: 4669979
Product Specifications
- Other Name: Servo - Speed Control; Cruise Control Servo; Actuator; Servo; Servo Speed Control
- Item Weight: 1.20 Pounds
- Item Dimensions: 5.4 x 4.9 x 4.9 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4669979
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2007 Jeep Grand Cherokee Submodels:
- 5.9 Limited, 65th Anniversary Edition, Laredo, Limited, Orvis, Overland, SRT8, Special Edition, Sport, TSi | 6 Cyl 3.0 L DIESEL, 6 Cyl 3.7 L GAS, 6 Cyl 4.0 L GAS, 8 Cyl 4.7 L FLEX, 8 Cyl 4.7 L GAS, 8 Cyl 5.2 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 5.9 L GAS, 8 Cyl 6.1 L GAS

2007 Jeep Grand Cherokee Cruise Control Servo Parts and Q&A

Q: How to Remove the Cruise Control Servo Assembly on 2007 Jeep Grand Cherokee?
A: First disconnect the negative power cable at the battery before handling the speed control servo assembly. After that, remove the vacuum line and the power wire from the servo. Take out the servo mounting bolt and cut the servo cable right at the throttle body. After that, take out the two nuts that hold the servo cable sleeve in place on the bracket. Pull back the speed control cable sleeve and servo out of their mounts to access and remove the cable locking clip. Lastly, pull the servo out from the bracket, being sure to keep a note of which side of the servo is facing up during your removal.