OEM 2008 Jeep Patriot Cruise Control Switch

2008 Jeep Patriot Cruise Control Switch Parts and Q&A

• Q: How to Install a Cruise Control Switch and Its Related Components on 2008 Jeep Patriot?

  A: Take the speed control switch and mount it on the locating pin in the steering wheel, making sure the rubber seal is fitted around the switch. Wire and mount the speed control switch with screws tightened to 1.6 Nm (15 ins. lbs.). Bring the side with the electrical connector to the speed control switch. Then, attach the horn switch to the steering wheel with mounting screws and tighten them to 8 Nm (71 ins. lbs.). Set up the driver's side air bag, next attach the negative battery cable to the bracket and tighten its nut to 5 Nm (45 in. lbs.). Check that the battery is charging again and that the vehicle runs well.