Remove the front bumper by starting with the end caps and only if your car has fog lamps, disconnect the fog lamp wirings. Separate the vacuum line from the reservoir and loosen the bolts that bind the bumper to its brackets with a Torx tool. Then, remove the bumper from the vehicle and, when arranged, take out the bolts holding the bumper mounts to the body. For set up, if the mounting brackets were taken off, reattach the bolts to the frame and tighten them to a maximum of 55 N.m (41 ft.lbs.) torque. Put the bumper in front of the vehicle and fasten it to the mounting brackets with the Torx bolts, making certain all bolts have the same tension. After that, link the vacuum line back to the reservoir, continue with the fog lamp wire connections if you have them and then fasten the end covers to your bumper.