Always review the warnings and cautions mentioned in your car's manual, paying close attention to the importance of turning off the
Air Bag to protect yourself from accidental injury. Position the I/P assembly onto the support hooks and underside pins in the car as you install it. Install the left side support nuts, tighten them to 21 Nm. Place the center support bolt and then tighten it to a force of 21 Nm. Splice the wire harness at the A-pillar, then connect the main wire harness at the cowl on the driver's side. Seat the center wire harness where it should go and attach the push pin fasteners. Attach the fence line bolts, putting them in tight to 21 Nm and link the HVAC wire harness connectors. Plug in the radio
Antenna and add the silencer pad to the passenger side. Tighten the bolts on the passenger side to 21 Nm, put the end cap onto the I/P and connect the wire harness above the passenger door. Attach the center I/P to HVAC screws after that and then place the compass module on top of the I/P and the radio. Cover the center bezel with the trim cover, lining it up properly so it sits properly. Put the reinforcement into place at the front of the steering column, attach the screws, cover the steering column opening with the cover and snap the clips into place. After that, add in the passenger air bag, the cowl side panels, the shifter and the floor console.