2000 Chrysler 300M Catalytic Converter, Exhaust Manifold, Exhaust Hanger, Exhaust Pipe

Catalytic Converter, Exhaust Manifold, Exhaust Pipe Installation and Repair Tips for 2000 Chrysler 300M

• Q:

  How to Properly Maintain Catalytic Converters on Both Sides on 2000 Chrysler 300M?

  A:

  The procedure involves service of the right catalytic converter by first cooling the exhaust system, lifting the vehicle and drainage of the exhaust. Turn off the oxygen sensor, and pull out the converter and put on a new V-Band clamp. In the case of the left converter, repeat, but with correct torque specifications and replacement of parts.
• Q:

  How to Maintain Your Exhaust Manifold Effectively on 2000 Chrysler 300M?

  A:

  To have the exhaust manifold service, un-hook the negative cable and lift the vehicle, and then un-bolt the exhaust system. Take out the A/C compressor, oxygen sensor and heat shield. Install new manifold, tighten bolts and reconnect. Do the same with the left manifold and make sure that the torque requirements are established correctly.
• Q:

  How to Service and Repair the Exhaust Pipe and Rear Resonator on 2000 Chrysler 300M?

  A:

  To service the tailpipe and rear resonator you will need to remove the exhaust system and loosen the assembly clamp. Remove and place the assembly onto the rear module, loosely attach the clamp and reinstall the exhaust system. Finally, tighten all band clamps to 61Nm (45 ft. lbs.).