2000 Chrysler Concorde Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2000 Chrysler Concorde

• Q:

  How to Remove and Install a Knock Sensor in an Engine on 2000 Chrysler Concorde?

  A:

  To remove a knock sensor that is located underneath the intake manifold, first remove the intake manifold plenum and passenger side cylinder head. Disconnect the electrical connector, and use a crows foot socket to remove it. Reinstall by tightening to 10 Nm then reassemble cylinder head and intake manifold.
• Q:

  How to Remove and Install Downstream Heated Oxygen Sensors at the Catalytic Converter Outlet on 2000 Chrysler Concorde?

  A:

  Replacement To remove downstream heated oxygen sensors, make sure that the engine is cool. Disconnect the negative battery cable, lift the vehicle and unplug the O2S connector. Removal should be done with a Snap-On wrench. Install the new sensor without applying any anti-seize, screw it, reconnect the O2S, roll down the vehicle and reconnect the battery.
• Q:

  How to Locate, Remove, and Install a Camshaft Position Sensor on 2000 Chrysler Concorde?

  A:

  The Camshaft Position Sensor will be located at the front of the timing case cover. To remove that, disconnect the electrical connector and unscrew the sensor. For installation, insert the sensor up to contact with the timing chain cover, tighten the bolt to 12 N.m and reconnect the electrical connector.