2000 Jeep Cherokee Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Exhaust Pipe, Muffler, Tail Pipe Installation and Repair Tips for 2000 Jeep Cherokee

• Q: How to Service an Exhaust Pipe on 2000 Jeep Cherokee?

  A: To service the exhaust pipe, jack up the vehicle and clean the bolts with Mopar Rust Penetrant. Disconnect the oxygen sensor and remove the exhaust pipe. Install the new pipe, pressing against the transmission support and exhaust manifold. Tighten any connections, reconnect sensor, lower vehicle and check for a leak.
• Q: How Should You Service and Repair an Early Build Catalytic Converter on 2000 Jeep Cherokee?

  A: To maintain the catalytic converter, be careful by not igniting fire around fuel lines and disconnection of oxygen sensor. Lift the car, get off clamps and unplug the oxygen sensor. Heat the connection to pull apart the parts then fit the new parts, screwing all the clamps and nuts to recommended torque.
• Q: How Are Muffler and Tail Pipe Serviced and Repaired on 2000 Jeep Cherokee?

  A: Original equipment exhaust systems have the tailpipe welded to the muffler and replacements are usually clamped or welded. Disconnect the oxygen sensor before removing. Heat connections and remove the assembly and install the new muffler and tailpipe, making sure that they are aligned and have proper torque. Finally, look for leaks and adjust accordingly.
• Q: How Are Muffler and Tail Pipe Assemblies Serviced and Repaired on 2000 Jeep Cherokee?

  A: The muffler and tailpipe assembly for late vehicles features a welded exhaust tailpipe. When servicing, avoid torches near the fuel line and disconnect the oxygen sensor. To remove, support the vehicle, disconnect hangers, and remove clamps. For installation, align components, then tighten the muffler and tailpipe clamps to specified torque.