2001 Chrysler Concorde Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2001 Chrysler Concorde

• Q:

  How to Locate, Remove, and Install a Knock Sensor on 2001 Chrysler Concorde?

  A:

  The knock sensor, located below the intake manifold in the cylinder block, requires the intake manifold plenum and passenger side cylinder head to be removed for replacement. After disconnecting the electrical connector and using a crows foot socket, install the new sensor, tightening it to 10 Nm (7 ft. lbs.) before reassembly.
• Q:

  How to Remove and Install a Camshaft Position Sensor on 2001 Chrysler Concorde?

  A:

  To remove the camshaft position sensor, simply remove the electrical connector, and unscrew it. Pull the sensor out of the chain case cover carefully. For installation, insert the sensor until it makes contact with the head, and tighten the bolt to 12 Nm (105 in. lbs.), and reconnect the electrical connector.
• Q:

  How to Replace an Engine's Upstream Heated Oxygen Sensor on 2001 Chrysler Concorde?

  A:

  In order to change the upstream heated oxygen sensor, disconnect the negative battery cable and the electrical connector of the sensor. A socket or crow foot wrench is used to remove the sensor, clean the threads, use anti-seize, tighten to 28 Nm, reconnect the electrical connector and reconnect the battery cable.