2002 Chrysler Prowler Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2002 Chrysler Prowler

• Q:

  How to Remove and Install a Camshaft Position Sensor in the Timing Belt Housing Cover on 2002 Chrysler Prowler?

  A:

  The camshaft position sensor is in the timing belt housing cover directly over the left camshaft sprocker. In order to do that, in order to eliminate it, simply de-electrically connect the battery, the upper intake plenum, and the electrical connector of the sensor. When reusing the sensor, install a new spacer, re-install and reconnect everything.
• Q:

  How to Effectively Remove and Install an Oxygen Sensor in an Engine on 2002 Chrysler Prowler?

  A:

  Two upstream oxygen sensors and two downstream oxygen sensors are provided on the engine. Make sure that the engine is cooled before a removal. Unplug the electrical connector, take off using a socket and clean the threads. Tighten to 28 Nm (20 ft. lbs.) and re-connect electrical connector.
• Q:

  How to Remove and Install a Knock Sensor in an Engine on 2002 Chrysler Prowler?

  A:

  To delete the knock sensor situated below the intake manifold, at first detach the intake manifold plenum and manifold. Disconnect the electrical connector of the sensor and use a crows foot socket to pull out the bolt. Reinstall by tightening the bolt to 10 Nm, reattaching the electrical connector and reattaching the manifolds.