2002 Dodge Ram 1500 Crankshaft Position Sensor, Engine Control Module, Ignition Coil, Spark Plug

Crankshaft Position Sensor, Ignition Coil, Spark Plug Installation and Repair Tips for 2002 Dodge Ram 1500

• Q:

  How to remove and install the Crankshaft Position Sensor on 2002 Dodge Ram 1500?

  A:

  The CKP sensor is located in a hole at the right rear of the engine block. Removal, typically with the vehicle raised, involves disconnecting the connector, removing the bolt and twisting the sensor free while O-ring is checked. Maintenance which comprises cleaning the bore, oil the O-ring, seat the sensor flush and tighten the bolt to 28 Nm (21 ft.lb).
• Q:

  How to replace a Spark Plug and ignition coils on 2002 Dodge Ram 1500?

  A:

  Generally, the tubing at the throttle body is removed; compressed air can blast around the coil base and into the head to prevent debris. The rubber insert socket is used to remove the plugs, followed by inspection. Coil O - rings replaced if needed. New plugs are hand-started and torqued to spec, and silicone may help O-ring installation on coil refit.
• Q:

  How to Install and Remove an Ignition Coil on 2002 Dodge Ram 1500?

  A:

  Each spark plug has its own individual ignition coil that is fastened to the intake manifold. To remove the coil, disconnect the electrical connector, clean the area and twist the coil out. For installation purposes, the O-ring should be in good condition, applying silicone, and fixing the coil and connector as required. Install back any deleted components.