2002 Jeep Grand Cherokee Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2002 Jeep Grand Cherokee

• Q: How to Maintain the Air Bag Control Module on 2002 Jeep Grand Cherokee?

  A: In order to service the air bag Control Module (ACM), remove the battery negative cable and wait two minutes. Take out the center console and unconnect the ACM connectors. Take away the ACM and replace it with the new one and reconnect the connectors. Install the center console back and do not reconnect battery until verification test has been done.
• Q: How to Service an Air Bag Sensor for Front Impact on 2002 Jeep Grand Cherokee?

  A: In order to maintain the front impact sensor, pull the battery negative cable out and wait 2 minutes. Unscrew the connector of the headlamp and two screws ensuring the sensor. Install new sensor and screw 10 Nm tight and reconnect harness. Always make sure that the system is turned off so that the airbags will not deploy accidentally.
• Q: What Steps Should Be Taken After an Airbag Deployment on 2002 Jeep Grand Cherokee?

  A: The deployed restraints should be replaced after a supplemental restraint deployment, and the vehicle should be returned to use. Check and repair the mounting surface of air bag Control Module and side impact sensors. Confirm that all air bag initiators were deployed. Properly dispose air bags according to the rules, make sure that they are fully deployed.
• Q: How to Replace a Faulty Clock Spring on 2002 Jeep Grand Cherokee?

  A: Clock Spring cannot be repaired and therefore replace in case of failure or as a result of airbag deployment. Turn off the restraint system, take out the airbag, steering wheel and disconnect the Clock Spring. Install the new Clock Spring once again, and in the proper position and the steering components and airbag.