2003 Chrysler Town & Country Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2003 Chrysler Town & Country

• Q:

  How to Maintain a Windshield Washer Fluid Reservoir on 2003 Chrysler Town & Country?

  A:

  In order to clean the windshield washer reservoir, unconnect the battery, take out the engine air housing, and loosen the washer hoses. Pour out the fluid, snap off electrical connections and take out the reservoir. Installation Re-Installation must be done in reverse so that the connections and torque requirements are met, and the system is checked.
• Q:

  How to Replace a Rear Wiper Motor on 2003 Chrysler Town & Country?

  A:

  In order to change the rear wiper motor, disconnect the battery negative cable, wiper arm, and the liftgate trim panel. Unconnect the wire connector and screws of the motor and take off the motor. Fit the new motor, fit the wire back, and fit the trim and wiper arm and lastly refit the battery.
• Q:

  How to Replace a Front Wiper Arm Without Causing Damage on 2003 Chrysler Town & Country?

  A:

  In order to replace front wiper arms, park the driver side on top of the passenger side. Wring off the arm cap and nut and then pull off the arm with a two-jaw puller. Make sure the wiper motor is in park position, screw in the arm with a nut tightly tightened to 35 Nm and put the cap back.