2004 Dodge Intrepid Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2004 Dodge Intrepid

• Q:

  How to Remove and Install a Camshaft Position Sensor on 2004 Dodge Intrepid?

  A:

  In order to take off the camshaft position sensor, loosen the electrical connector, unscrew it and loosen the chain case cover and pull it. To install, insert the sensor until it clips into the head, attach it using a 12 Nm bolt and reconnect the electrical connector.
• Q:

  How to Remove and Install an Engine's Oxygen Sensor on 2004 Dodge Intrepid?

  A:

  To remove the upstream heated oxygen sensor, disconnect the negative battery cable and the sensor's electrical connector. Use a socket or crow foot wrench for removal. Clean the threads, apply anti-seize if reusing, tighten to 28 N.m, reconnect the electrical connector, and reinstall the battery cable.
• Q:

  How to Locate, Remove, and Install a Knock Sensor on 2004 Dodge Intrepid?

  A:

  The knock sensor is located below the intake manifold and therefore the intake manifold plenum and passenger side cylinder head must be removed for replacement. Disconnect and using a crows foot socket remove the electrical connector and install the new sensor with a torque of 10 Nm. Reassemble the components after.