2004 Dodge Ram 2500 Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Airbag, Clock Spring Installation and Repair Tips for 2004 Dodge Ram 2500

• Q:

  How to Safely Remove and Install an Air Bag Control Module for Side Impact Airbags on 2004 Dodge Ram 2500?

  A:

  To service the Side Impact air bag Control Module (Siacm) - turn off the supplementary restraint system by disconnecting the battery negative cable. Remove necessary parts to get to the Siacm and then replace it, being careful of screw torque. If dropped, replace the Siacm so the air bag will not deploy improperly.
• Q:

  How to Replace a Faulty Clock Spring on 2004 Dodge Ram 2500?

  A:

  With faulty or after airbag deployment, replace the Clock Spring as it cannot be repaired. Disable the restraint system, remove the airbag and steering wheel and the Clock Spring. Install a new Clock Spring, making sure you center it, and back on the steering components, connect the airbag again.
• Q:

  What Should You Do When Your Airbag Deploys in a Collision on 2004 Dodge Ram 2500?

  A:

  The airbag system should be disabled after a collision and then related components serviced. Disconnect the battery, wait two minutes and remove all restraints deployed. Check mounting surfaces to airbag modules. Wipe down the inside of any powder residue with safety equipment, and clean up the airbags and seat belt tensioner which were deployed according to regulations.