2005 Chrysler 300 Crankshaft Position Sensor, Engine Control Module, Ignition Coil, Spark Plug

Crankshaft Position Sensor, Ignition Coil, Spark Plug Installation and Repair Tips for 2005 Chrysler 300

• Q:

  How to service the Crankshaft Position Sensor on 2005 Chrysler 300?

  A:

  Servicing the crankshaft position sensor usually starts with the negative battery cable being disconnected and the vehicle supported, before unlocking and unplugging the electrical connector so the mounting bolt and sensor can be removed. After reinstalling, the new sensor was secured to 12Nm (105 in.lb), the connector reattached and lowered, and battery cable restored.
• Q:

  How to service and repair the Spark Plug on 2005 Chrysler 300?

  A:

  The negative battery cable is usually disconnected and the intake manifold removed; air may be used to clear the plug tube. For certain engines, coil screws are loosened alternately to maintain spacers. The coils were taken off the plugs which were pulled with a rubber socket and hand-started and tightened to 17 Nm. Coils were refitted and screws torqued to 6.7 Nm.
• Q:

  How to Service an Ignition Coil on 2005 Chrysler 300?

  A:

  To maintain the ignition coil, pull out the negative battery cable, and the intake manifold. De-debride the area using compressed air, unscrew the electrical connector and take out the ignition coil assembly. Installation Alternatively install using screws, reconnect the electrical connector, and re-install the intake manifold and battery cable.