2005 Chrysler Town & Country Clock Spring, Airbag, Air Bag Control Module, Air Bag Sensor

Air Bag Control Module, Air Bag Sensor, Airbag, Clock Spring Installation and Repair Tips for 2005 Chrysler Town & Country

• Q:

  How to Maintain a Clock Spring Assembly on 2005 Chrysler Town & Country?

  A:

  To service the Clock Spring Assembly, align the steering wheel, disconnect the battery and wait for two minutes. Remove the driver air bag, steering wheel and shrouds. Unplug a number of different connectors; then remove and replace the Clock Spring. Put components back together, being sure to make connections and torx requirements before replacing the battery.
• Q:

  What Needs Inspection and Replacement After an Airbag Deployment on 2005 Chrysler Town & Country?

  A:

  Replacement of deployed Driver air bag, Clock Spring Assembly, Steering Wheel, and Steering Column Assembly should be done after a collision. In the case of Passenger, Knee Blocker and Curtain air bags, change their corresponding assemblies and examine other parts to see damages. Check and change parts of the OCS when necessary, but do not always change ORC and OCM.
• Q:

  How to Safely Service the Air Bag Control Module on 2005 Chrysler Town & Country?

  A:

  To service the Air Bag Control Module, disconnect the battery negative cable and wait for two minutes. Remove the storage bin and three bolts that hold the Occupant Restraint Controller (ORC). Install the ORC properly as well as torque bolts to 7.3 - 9.6 Nm, and then perform an air bag system test before reconnecting the battery.
• Q:

  How to Service Air Bag Sensors Mounted on Front Rail Tips on 2005 Chrysler Town & Country?

  A:

  To maintain the front impact sensors, open the hood, disconnect the negative cable of the battery and wait two minutes. Lift the car, remove the sensor and take it off. Install the new sensor using screws, reconnect the electrical connector, lower the vehicle, and do a system test, and close the hood.