2005 Dodge Dakota Catalytic Converter, Exhaust Manifold, Exhaust Hanger, Exhaust Pipe

Catalytic Converter, Exhaust Manifold, Exhaust Pipe Installation and Repair Tips for 2005 Dodge Dakota

• Q:

  How to Maintain and Fix an Exhaust Pipe on 2005 Dodge Dakota?

  A:

  To fix the exhaust pipe, lift the vehicle up and spray the bolts with Mopar(R) Rust Penetrant. Remove the exhaust pipe and muffler clamps, insulators and rusted areas. Install the new components ensuring alignment is good and tighten the clamp. Finally, check for leaks after bringing down the car and starting the engine.
• Q:

  How to Remove and Install a Catalytic Converter on a 3.7L or 4.7L Engine on 2005 Dodge Dakota?

  A:

  To remove a catalytic converter on a 3.7L or 4.7L engine, you will need to raise the vehicle, use a Mopar(R) Rust Penetrant and disconnect the oxygen sensor. Remove bolts and clamps, grind tack welds if necessary and check for damage. For installation be sure to check for proper alignment, new clamps, and check for leaks when lowering the vehicle.
• Q:

  How to Service an Exhaust Manifold on 2005 Dodge Dakota?

  A:

  To repair the exhaust manifold, disconnect the battery, lift the car and remove the exhaust pipe. Remove the heat shield, and then remove the manifold and gasket. Install the new manifold with sealer installed on any studs and tighten to specified torque and reassemble exhaust pipe and heat shields.