2005 Dodge Grand Caravan Crankshaft Position Sensor, Engine Control Module, Ignition Coil, Spark Plug

Engine Control Module, Ignition Coil, Spark Plug Installation and Repair Tips for 2005 Dodge Grand Caravan

• Q:

  How to Service the NGC Controller and Replace the Engine Control Module on 2005 Dodge Grand Caravan?

  A:

  Before replacing the Pcm, the vehicle must have covered at least 320km (200 miles) to service the Ngc Controller. Enter the new Pcm with the mileage and Vin by the use of Drbiii(R) scan tool. Disassemble the battery, the splash shield, and change the Pcm. Re-connected all and programmed the new Pcm.
• Q:

  How to Service and Repair an Ignition Coil on 2005 Dodge Grand Caravan?

  A:

  To repair ignition coil, disconnect the negative battery cable, get rid of power steering reservoir and ignition cables. Remove the ignition coil then install the new coil and reconnect all. Finally, put the power steering reservoir in place, reattach the throttle and speed control cables, and attach the battery cable again.
• Q:

  How to correctly replace spark plugs and Spark Plug cables on 2005 Dodge Grand Caravan?

  A:

  Usually, the cables are routed and clipped into retainers to prevent ignition noise, cross-fire or shorts when spark plugs and cables are replaced. The use of compressed air helps remove plugs using a foam-insert socket, which is then inspected. Threads are anti-seized, started by hand to avoid cross-threading, torqued to 17.5 Nm, cables seated until click.