2006 Chrysler PT Cruiser Crankshaft Position Sensor, Engine Control Module, Ignition Coil, Spark Plug

Crankshaft Position Sensor, Ignition Coil, Spark Plug Installation and Repair Tips for 2006 Chrysler PT Cruiser

• Q:

  Where is the Crankshaft Position Sensor located, and How to replace it on 2006 Chrysler PT Cruiser?

  A:

  The crankshaft sensor is usually located underneath the starter motor near the engine block. To replace the negative battery cable remove the cable first. The connection on some 2.4L SRT-4 applications involves removal of hoses and collar, unlocking connector, unbolting sensor, checking/lubing O-ring and installation with a twist. Finally torque to 9 Nm (80 ±15 in.lbs).
• Q:

  How should a Spark Plug be properly serviced on 2006 Chrysler PT Cruiser?

  A:

  Usually, cables are always routed to prevent ignition noise or shorts; the air cleaner, sensors and battery are disconnected; the upper intake is removed; the boots are rotated 90° at the insulator and pulled off. Use a rubber-insert socket to remove plugs. Inspect plugs, install finger-tight, and torque to 17.5±2 Nm (13±2 ft.lbs). Re-seal tube ends and re-assemble parts.
• Q:

  How to Remove and Install an Ignition Coil Identified by Part Number COIL-IGNITION on 2006 Chrysler PT Cruiser?

  A:

  To change the electronic ignition coil pack (part number COIL-IGNITION) the negative battery cable should be disconnected, the electrical connector should be pulled off, and spark plug cables should be removed. Removing the coil pack and the mounting bolts. Install the new pack, clench the bolts to 12 N.m, rebuild the cables and reattach the battery connection.