2006 Chrysler Sebring Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Engine Control Module, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2006 Chrysler Sebring

• Q:

  How to Service and Reprogram the Engine Control Module with the Original Identification Number and Mileage on 2006 Chrysler Sebring?

  A:

  To service the Engine Control Module, reprogram the new PCM with the vehicle's VIN and mileage using a scan tool to avoid DTCs. Disconnect the negative battery cable, remove the PCM and install the new one. Finally reconnect all and reprogram the mileage and VIN.
• Q:

  How to Maintain a Knock Sensor on a 4-Cylinder Engine on 2006 Chrysler Sebring?

  A:

  To service the knock sensor on a 4-cylinder engine, disconnect the electrical connector and remove the sensor with a crow foot socket. Install the new sensor in the same location, tightening it to 10 N.m (7 ft. lbs.) to ensure proper performance, then reconnect the electrical connector.
• Q:

  How to Remove and Reinstall an Oxygen Sensor in the Exhaust Manifold on 2006 Chrysler Sebring?

  A:

  In order to take out the heated oxygen sensor in the exhaust manifold, loosen the negative battery cable and the electrical connector of the sensor. Remove with a socket or crow foot wrench, clean up the threads, apply anti-seize (when reusing), and tighten to 28 N.m and reconnect electrical connector, and replace battery cable.
• Q:

  How to Install and Replace a Camshaft Position Sensor on 2006 Chrysler Sebring?

  A:

  In order to change the camshaft position sensor, take off the negative battery cable and PCV hose. The sensor can be removed by eliminating electrical connections and screws. Unscrew the target magnet screw and unscrew the target magnet and screw in with a new magnet. Install sensor, screws, PCV hose and battery cable back.