2006 Dodge Durango Catalytic Converter, Exhaust Manifold, Exhaust Hanger, Exhaust Pipe

Catalytic Converter, Exhaust Manifold, Exhaust Pipe Installation and Repair Tips for 2006 Dodge Durango

• Q:

  How to Service and Repair an Exhaust Pipe on 2006 Dodge Durango?

  A:

  To fix the tailpipe, lift the vehicle and use Mopar Rust Penetrant on bolts. Remove the exhaust pipe and anything else that has rust, replacing it with the original equipment. Install the exhaust pipe and muffler, align properly. Tighten the clamp, lower the vehicle and check for exhaust leaks.
• Q:

  How to Maintain an Exhaust Manifold on 2006 Dodge Durango?

  A:

  Disconnection of the battery, lifting of the vehicle and pulling off of the exhaust pipe are needed to service the exhaust manifold. Pull out the heat shield, then the manifold and the gasket. Install new studs where necessary, lay the manifold, and clamp it to required torque. Refit the heat shield and exhaust pipe.
• Q:

  How to Maintain and Fix a Catalytic Converter on 2006 Dodge Durango?

  A:

  For repairing the catalytic converter, lift the vehicle and apply Mopar Rust Penetrant on exhaust bolts. Disconnect the oxygen sensor, remove bolts and clamps and look for damage. Install the new converter, aligning and checking for clearance, and tighten bolts and clamps. Finally, look for exhaust leaks.