2006 Dodge Stratus Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Engine Control Module, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2006 Dodge Stratus

• Q:

  How to Program the Secret Key into a New Engine Control Module After Replacement on 2006 Dodge Stratus?

  A:

  In order to program the secret key into the new Pcm, one has to leave the ignition on, with the transmission in park or neutral. Click on the scan tool, pick Theft Alarm, then Skim, pick Pcm Replaced (Gas Engine). Change Pcm Vin by entering the four digit Pin and responding to odometer prompts.
• Q:

  How to Install and Replace a Camshaft Position Sensor on 2006 Dodge Stratus?

  A:

  In order to change the camshaft position sensor, take off the negative battery cable and PCV hose. The sensor can be removed by eliminating electrical connections and screws. Unscrew the target magnet screw and unscrew the target magnet and screw in with a new magnet. Install sensor, screws, PCV hose and battery cable back.
• Q:

  How to Remove and Reinstall an Oxygen Sensor in the Exhaust Manifold on 2006 Dodge Stratus?

  A:

  In order to take out the heated oxygen sensor in the exhaust manifold, loosen the negative battery cable and the electrical connector of the sensor. Remove with a socket or crow foot wrench, clean up the threads, apply anti-seize (when reusing), and tighten to 28 N.m and reconnect electrical connector, and replace battery cable.
• Q:

  How to Maintain a Knock Sensor on a 4-Cylinder Engine on 2006 Dodge Stratus?

  A:

  To service the knock sensor on a 4-cylinder engine, disconnect the electrical connector and remove the sensor with a crow foot socket. Install the new sensor in the same location, tightening it to 10 N.m (7 ft. lbs.) to ensure proper performance, then reconnect the electrical connector.