2007 Chrysler Pacifica Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2007 Chrysler Pacifica

• Q:

  How to Remove and Service a Windshield Windshield Washer Fluid Reservoir on 2007 Chrysler Pacifica?

  A:

  To service the windshield washer reservoir, disconnect the battery negative cable, hoist the vehicle and remove screws from left wheel splash shield and lower fascia push pins. Disengage the bottom fascia clips, enter the reservoir and remove its holding bolts and filler tube bolt before removing it.
• Q:

  How to Service and Repair a Wiper Motor on 2007 Chrysler Pacifica?

  A:

  To repair the wiper motor, start by disconnecting the battery's negative cable. Then, remove the wiper module. On a bench, separate the socket and ball joint at the bell crank's end. Lastly, take out the three mounting bolts and remove the motor from the module/linkage.
• Q:

  How is the Rear Wiper Arm Installed on 2007 Chrysler Pacifica?

  A:

  To install the rear wiper arm, place the rear wiper arm on the rear wiper motor shaft with the wiper blade on the lower EBL line. Then, tighten the rear wiper arm retaining nut to 9 Nm (80 in. lbs.) and close the rear wiper arm nut cover.