2007 Chrysler Sebring Catalytic Converter, Exhaust Manifold, Exhaust Hanger, Exhaust Pipe

Catalytic Converter, Exhaust Manifold, Exhaust Pipe Installation and Repair Tips for 2007 Chrysler Sebring

• Q:

  How to Remove and Replace a Catalytic Converter in a 2.0/2.4L Engine on 2007 Chrysler Sebring?

  A:

  With the 2.0/2.4L engine, to replace the catalytic converter, clean the manifold surfaces and place a new gasket, and transfer the downstream oxygen sensor. Loosely connect the converter and resonator/pipe assembly and tighten fasteners. Connect the ground strap, check for leakage and make sure a proper clearance with body panels.
• Q:

  How to Replace an Exhaust Manifold on 2007 Chrysler Sebring?

  A:

  To fit a new gasket (no sealer) into the vacuum, insert the new exhaust manifold, and the manifold, and screw to 34 Nm. Install heat shields and attach to 12 Nm. Connect the support bracket, catalytic converter gasket, and exhaust pipe and tighten them to 28 Nm. Install the oxygen sensor and negative battery cable and fit the engine cover.
• Q:

  How Is an Exhaust Pipe Installed on 2007 Chrysler Sebring?

  A:

  To have the exhaust pipe installed, a new gasket is placed on the rear catalytic converter, oxygen sensors are transferred if necessary and the cross-under pipe is loosely attached. Tighten all nuts to 28 Nm. Connect exhaust system. reinstall oil pan. reconnect sensors. check for leaks, contact with body panels.