2007 Dodge Caliber Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2007 Dodge Caliber

• Q:

  How to Install a Wiper Motor for the Rear Window on 2007 Dodge Caliber?

  A:

  Installing the rear wiper motor requires installation of a new rubber grommet into the liftgate glass, examination of the U-nuts, and lubrication of the motor output shaft. Attach the shaft to the grommet, install the motor, reconnect the wire harness, install the trim, install the wiper arm and reconnect the battery.
• Q:

  What is the Correct Method to Install a Rear Wiper Arm on 2007 Dodge Caliber?

  A:

  Before installing the rear wiper arm make sure the motor is set in the park position. Align the wiper arm with the rear window defogger grid and secure it to the output shaft of the motor with a nut that is tightened to 9 Nm. Test the position of the wiper and re-adjust if necessary, then replace the nut cap.
• Q:

  How to Remove the Windshield Washer Fluid Reservoir on 2007 Dodge Caliber?

  A:

  To remove the windshield washer reservoir, disconnect the negative battery cable, then fasteners holding the coolant container. Siphon the washer fluid, disconnect the wire harness and the hoses, remove the screw holding the reservoir in place. Finally, work the reservoir up to disengage and remove from the engine compartment.