2007 Dodge Dakota Catalytic Converter, Exhaust Manifold, Exhaust Hanger, Exhaust Pipe

Catalytic Converter, Exhaust Manifold, Exhaust Pipe Installation and Repair Tips for 2007 Dodge Dakota

• Q:

  How to Install an Exhaust Pipe on 2007 Dodge Dakota?

  A:

  To install the exhaust pipe, take off any burrs and remove the pipe to the muffler, making sure to get the alignment correct. Loosely install the muffler-to-exhaust pipe clamp. If removed, put in the rear muffler and tail pipe insulators. Tighten clamp to 61Nm, check for leaks and replace band clamps after removal.
• Q:

  How to Maintain or Replace a Catalytic Converter on a 3.7L or 4.7L Engine on 2007 Dodge Dakota?

  A:

  In order to service or replace the catalytic converter of a 3.7L or 4.7L engine, raise the vehicle and apply Mopar(R) Rust Penetrant to exhaust bolts. Disassemble the oxygen sensor, and then do away with the catalytic converter-to-manifold bolts and exhaust pipe clamp. Welds of tack are to be grounded off.
• Q:

  How to Effectively Service and Repair an Exhaust Manifold on 2007 Dodge Dakota?

  A:

  To repair the exhaust manifold, disconnect the negative battery cable, lift the vehicle, and remove the bolts on the exhaust pipe. Then, remove the heat shield, manifold bolts and gasket and repeat on all sides, following all steps for both exhaust manifolds.