2007 Dodge Ram 3500 Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Exhaust Pipe, Muffler Installation and Repair Tips for 2007 Dodge Ram 3500

• Q:

  How to Install a Muffler on 3.7L, 4.7L, and 5.7L Engines on 2007 Dodge Ram 3500?

  A:

  In order to fit the muffler to 3.7L/4.7L/5.7L, loosely fit the muffler and clamps to make them fit. Connect hangers and clamp nut screwdriver to 54 Nm (40 ft. lbs.). Make sure that 25 mm (1.0 in.) clearance is maintained between bodys panels, and increase or decrease as necessary, and check exhaust leakage after cranking.
• Q:

  How to Service and Repair a Catalytic Converter on a 5.7L Engine on 2007 Dodge Ram 3500?

  A:

  To service the catalytic converter on a 5.7L engine, raise the vehicle and apply heat valve lubricant to the bolts. After 5 minutes, disconnect the oxygen sensor, remove clamps and nuts, then take out the bolts securing the converter to the exhaust manifold, and finally, remove the assembly.
• Q:

  How to Service and Repair an Exhaust Pipe on 3.7L/4.7L/5.7L Engines on 2007 Dodge Ram 3500?

  A:

  To repair the exhaust pipe on 3.7L/4.7L/5.7L engines, elevate the vehicle and apply heat valve lubricant to the clamp nuts, letting it sit for 5 minutes. Disconnect the exhaust tailpipe support hanger, then remove the clamps and nuts, and finally take off the exhaust tailpipe.