2008 Chrysler 300 Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2008 Chrysler 300

• Q:

  How to Remove the Front and Rear Wiper Arms on 2008 Chrysler 300?

  A:

  To remove the front wiper arm, remove the nut caps, then remove the retaining nuts. Use a two-jaw puller to pull the wiper arm off the pivot. For the rear wiper arm, remove the nut cap and retaining nut and rock the arm to drop it before removal.
• Q:

  How to Maintain a Wiper Motor on 2008 Chrysler 300?

  A:

  To service the front wiper engine, disconnection of the battery negative cable with removal of the wiper unit. Instead, leave the bellcrank nut in so as not to have timing problems. Unscrew the linkage off the bellcrank, take out the motor mounting bolts and put the pocket nuts back on to screw it back into place then part the motor.
• Q:

  How to Maintain and Fix a Windshield Washer Fluid Reservoir on 2008 Chrysler 300?

  A:

  To service the windshield washer reservoir, disconnect the battery negative cable and remove the front fascia. Disconnect the electrical harness and hose, draining fluid into a container. Remove the rear mounting fastener and other fasteners before taking the reservoir out of the vehicle.