2008 Chrysler Pacifica Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Exhaust Pipe, Muffler Installation and Repair Tips for 2008 Chrysler Pacifica

• Q:

  How to Safely Detach an Exhaust Pipe on 2008 Chrysler Pacifica?

  A:

  To remove the exhaust pipe, disconnect the negative battery cable, raise the vehicle and remove the flange nuts at the exhaust manifold. Loosen the band clamp, separate the pipe from the muffler and clean up all the parts. Use original equipment or equivalent parts for replacements to assure proper function.
• Q:

  How to Install a Catalytic Converter on a 3.8L Engine on 2008 Chrysler Pacifica?

  A:

  In order to install catalytic converter on 3.8L engine, In this case first attach downstream oxygen sensor and tighten it to 41Nm. Set converter at position of muffler, connect to exhaust manifold with new gasket and must have clearance of 25 mm. Tighten all clamps and reconnect the sensor and check for leaks.
• Q:

  How to Install a Exhaust Resonator, Muffler and Ensure There Are No Exhaust Leaks on 2008 Chrysler Pacifica?

  A:

  Support the muffler and resonator assembly, then install the insulators. Position and tighten the band clamp nut to 54 Nm (40 ft. lbs.). Start the engine to check for exhaust leaks and repair as needed. Also, inspect for contact with body panels and adjust accordingly.