2008 Chrysler Sebring Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Exhaust Pipe, Muffler Installation and Repair Tips for 2008 Chrysler Sebring

• Q:

  How to Install a Muffler for Optimal Performance on 2008 Chrysler Sebring?

  A:

  Installation of the muffler and resonator assembly should be done by placing it over the catalytic converter pipe and fitting support isolators. Linearize to clearance, tie band clamp 54 Nm and attach ground strap. Once the vehicle has been lowered, examine the presence of exhaust leakage, and that there is no contact between its body parts, modifying them accordingly.
• Q:

  How to Maintain an Exhaust Pipe for Optimal Performance on 2008 Chrysler Sebring?

  A:

  To service the exhaust system, raise the vehicle on a hoist and ensure components are cool. Disconnect the downstream oxygen sensor, remove the oil pan to transmission collar, disconnect the exhaust pipe from the cross-under pipe, and remove fasteners attaching the cross-under pipe to the catalytic converters before removing it.
• Q:

  How to Remove and Replace a Catalytic Converter on a 2.0/2.4L Engine on 2008 Chrysler Sebring?

  A:

  In order to replace the catalytic converter on a 2.0/2.4L engine, you will need to clean the sealing surfaces, place a new gasket, and transfer the down stream oxygen sensor. Loosely attach the converter/resonator/pipe assembly then tighten fasteners. Connect the ground strap, check for leaks and check for proper clearance with body panels.