2008 Dodge Avenger Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2008 Dodge Avenger

• Q:

  How to Service a Wiper Motor on 2008 Dodge Avenger?

  A:

  To maintain the wiper motor the first step is to disconnect the negative battery cable. A pry bar should be used to carefully loosen the linkage on the crack ball stud. Finally, unscrew the three retaining bolts of the wiper module and take off the motor.
• Q:

  How to remove a Wiper Arm on 2008 Dodge Avenger?

  A:

  To remove the wiper arm, begin by putting the wiper arm/blades in the PARK position and turning off the ignition. Unsnap the nut cover and then loosen and remove the retention nut. Finally, use a universal claw puller to extract the arm from the pivot and pull it off.
• Q:

  How to Maintain a Windshield Washer Fluid Reservoir on 2008 Dodge Avenger?

  A:

  To service the windshield washer reservoir, disconnect the negative cable of the battery, and the washer fluid hose at the in-line connector. Remove (partly), if necessary, the bumper fascia. Disconnect the washer pump wire and mounting tab, remove the bolts on the reservoir and drain the fluid into a container.