2008 Dodge Avenger Catalytic Converter, Exhaust Manifold, Exhaust Hanger, Exhaust Pipe

Catalytic Converter, Exhaust Manifold, Exhaust Pipe Installation and Repair Tips for 2008 Dodge Avenger

• Q:

  How to Install an Exhaust Pipe on 2008 Dodge Avenger?

  A:

  Installing the cross pipe will require attaching a new gasket on the rear catalyst converter, shifting oxygen sensors (where necessary) and simply connecting the cross-under pipe. Tighten the nuts to 28 Nm and attach the exhaust system, fit the oil pan, re-fit the sensors, leak test and body contact inspection.
• Q:

  How to Remove and Replace a Catalytic Converter on a 2.0/2.4L Engine on 2008 Dodge Avenger?

  A:

  To replace the catalytic converter on a 2.0/2.4L engine, take the vehicle up and cool down the exhaust. Apply penetrating oil to the band clamp and fasteners, remove the ground strap and loosen the band clamp. Remove rubber isolators, the oxygen sensor, flange nuts and the catalytic converter.
• Q:

  How to Remove an Exhaust Manifold on 2008 Dodge Avenger?

  A:

  To remove the exhaust manifold on a front wheel drive vehicle, first, remove the engine cover and negative battery cable. Remove the upper heat shield bolts, disconnect the exhaust pipe, oxygen sensor, remove the support bracket and lower heat shield. Finally, take off the manifold fasteners and gasket.