2008 Dodge Durango Oxygen Sensor, Engine Control Module, Camshaft Position Sensor, Knock Sensor

Camshaft Position Sensor, Knock Sensor, Oxygen Sensor Installation and Repair Tips for 2008 Dodge Durango

• Q:

  How is a Knock Sensor Installed and Replaced in an Engine on 2008 Dodge Durango?

  A:

  The two knock sensors, which are located under the intake manifold, must be replaced as a pair because there is a common wiring harness. The left sensor has a larger head of the bolt and marked as the left sensor. Remove the intake manifold, disconnect the harness and carefully remove the sensors without the use of adhesives.
• Q:

  How to Maintain and Fix an Oxygen Sensor on 2008 Dodge Durango?

  A:

  Service The oxygen sensor requires the engine to be cool. To have a 4-sensor system, raise the vehicle and take off the right-front tire. Un-attach the O2S sensor wire, remove the sensor with a tool, and clean the exhaust pipe threads. Connectors should not have grease or be soldered over.
• Q:

  How to Locate and Remove the Camshaft Position Sensor on 2008 Dodge Durango?

  A:

  Camshaft Position Sensor (CMP) is found on the top/front of the right cylinder head. This is to be removed by disconnection of the electrical connector followed by removing the mounting bolt. Turn the sensor of the cylinder head softly and examine the condition of the o-ring.