2008 Dodge Grand Caravan Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Exhaust Pipe, Muffler Installation and Repair Tips for 2008 Dodge Grand Caravan

• Q:

  How to Remove the Catalytic Converter from a 3.3/3.8L Engine on 2008 Dodge Grand Caravan?

  A:

  In order to dismount a 3.3/3.8L engine catalytic converter, it is essential to loosen the clamp and detach the muffler and resonator to the catalytic converter pipe. Then, disconnect the oxygen sensor at the downstream. Lastly, loosen the bolts that hold the catalytic converter to the exhaust manifold and weaken the converter with the gasket.
• Q:

  How to Install a Muffler Assembly on 2008 Dodge Grand Caravan?

  A:

  To install the muffler / resonator assembly, bring it between the rear axle and body, connecting it to the catalytic converter without tight band clamp. Install it into the isolators, being careful not to tighten clamps too much. Finally, tighten the band clamp to 55 Nm, check there are no leaks and adjust if necessary.
• Q:

  How to Install the Exhaust Pipe for a 3.3/3.8L Engine on 2008 Dodge Grand Caravan?

  A:

  Installation of the cross-over pipe that has to be used to install the 3.3/3.8L engine should be done to fit at the manifold connections using new gaskets. Both banks should have tighteners set to 41 Nm (30 ft. lbs.). Having lowered the vehicle, look at exhaust leaks and verify that the system does not touch on body panels.