2008 Dodge Sprinter 3500 Door Hinge, Door Check, Door Latch Assembly, Exterior Door Handle

Door Check, Door Hinge, Door Latch Assembly, Exterior Door Handle Installation and Repair Tips for 2008 Dodge Sprinter 3500

• Q:

  How to Service and Repair a Left Door Latch Assembly on 2008 Dodge Sprinter 3500?

  A:

  To service the left door latch, remove the door trim, the inner latch handle, and bolts in the rear end door lock. Then, press the lock inwards to access the upper and lower latches. Mark their locations, disconnect cables and remove bolts to achieve the process.
• Q:

  How to Install a Front Door Check on 2008 Dodge Sprinter 3500?

  A:

  To install the check on the front door, fix them with bolts at 9 Nm. Connect it to the A-pillar, fixing the bolt at 23 Nm. Install the watershield, speaker and connect the speaker electrical connector. Finally install the front door control unit and door trim panel.
• Q:

  How to Remove a Door Hinge on 2008 Dodge Sprinter 3500?

  A:

  To remove the hinge from the front door, you should first remove the door. Next, make marks for the hinge position with a grease pencil before unscrewing bolts 1 and 3, and then removing hinges 2 and 4.
• Q:

  How to Install a Sliding Exterior Door Handle on 2008 Dodge Sprinter 3500?

  A:

  To install the sliding door handle, insert the exterior handle into the door, position the seal, and place the cap. Secure with the bolt, tightening to 3 Nm (26.5 in. lbs.), then finish by placing the trim cap over the assembly.