2008 Jeep Grand Cherokee Door Hinge, Door Check, Door Latch Assembly, Exterior Door Handle

Door Hinge, Door Latch Assembly, Exterior Door Handle Installation and Repair Tips for 2008 Jeep Grand Cherokee

• Q:

  How to Remove a Front Door Latch Assembly on 2008 Jeep Grand Cherokee?

  A:

  To remove the front door latch, raise the front window and set the watershield aside. Disconnect the actuator rods from the exterior handle and the interior handle rod from the latch. Then, disconnect the door wire harness, remove the three bolts, and take out the latch and actuator rods as an assembly.
• Q:

  How to Install a Front Exterior Door Handle on 2008 Jeep Grand Cherokee?

  A:

  Installation of the exterior handle on the front door To install the front door exterior handle, install the lock cylinder into the handle. Install the handle into the mounting hole using three bolts that are tightened to 7 Nm (60 in. lbs.). Install the door glass and connect the actuator rods, as well as adjust the latch (as needed).
• Q:

  How to Replace a Door Hinge Without Taking the Door Off on 2008 Jeep Grand Cherokee?

  A:

  In order to replace rear door hinges, one by one and leave off the door. Open front door, disconnect rear door wire harness and mark locations of hinges. Hold the back door in place, take 5 bolts, and take them off at a slow pace. Washers and hinge nuts are to be removed.