2008 Jeep Patriot Camshaft, Timing Chain, Timing Cover, Cam Gear

Cam Gear, Camshaft, Timing Cover Installation and Repair Tips for 2008 Jeep Patriot

• Q: How to Remove a Timing Cover on 2008 Jeep Patriot?

  A: In order to remove the timing cover, it's best to start by removing the engine cover, bleeding off fuel pressure, and disconnecting the battery. Remove the coolant recovery bottle, power steering reservoir and various hoses. S disconnect the ignition coil, remove the cylinder head cover and lower splash shield. Then, remove the A/C compressor, oil seal and timing chain cover.
• Q: How to Remove a Camshaft on 2008 Jeep Patriot?

  A: In order to remove camshaft, disconnect battery, coil connections and cylinder head cover. Lift, match timing marks and mark chain link. Unscrew the tensioner, compare the timing marks and place Locking Wedge 9701. Take off bearer cap bolts, raise the intake camshaft and fasten the timing chain with wire.
• Q: How to Safely Handle Cam Gear When Removing and Replacing the Timing Chain on 2008 Jeep Patriot?

  A: As an alternative to timing chain, it is important to note that the assemblage of camshaft sprockets and phasers cannot be serviced individually. You should never apply an impact wrench to the sprocket bolts or they become damaged. Install the camshaft phaser, lifters and push rods according to the correct procedures.