2009 Chrysler Town & Country Door Hinge, Door Latch Assembly, Door Lock Actuator Motor, Exterior Door Handle

Door Hinge, Door Latch Assembly, Exterior Door Handle Installation and Repair Tips for 2009 Chrysler Town & Country

• Q:

  How to Install a Front Exterior Door Handle on 2009 Chrysler Town & Country?

  A:

  Install the front exterior door handle, place the handle and attach the lock cylinder (where necessary), install and tighten the lock cylinder with three bolts of 5 Nm. Connect the linkage rods, install the door lock cylinder shield, the round close-out plug and lastly, install the front door trim panel.
• Q:

  How to Install a Door Hinge on 2009 Chrysler Town & Country?

  A:

  To install the front door hinge, paint it if it is necessary and then position and tighten the retaining bolts to the value of 33 Nm. With help, align the door to the hinges, loosely install nuts and tighten them. Connect wire harness, engage grommet, reconnect battery and check door alignment.
• Q:

  How to Service and Repair a Sliding Door Latch Assembly for Front on 2009 Chrysler Town & Country?

  A:

  To repair the sliding door front latch, disconnect the battery negative cable, remove the door trim panel and module access grommet, then take out the three mounting fasteners. Remove the latch through the access hole, disconnect the latch cable, and finally take the latch out of the vehicle.