2009 Dodge Durango Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Muffler, Tail Pipe Installation and Repair Tips for 2009 Dodge Durango

• Q:

  How to Install a Catalytic Converter for a 3.7L/4.7L Engine on 2009 Dodge Durango?

  A:

  Installation of catalytic converter assembly 3.7L/4.7L To install the catalytic converter assembly, it should have no burrs. Install it into the exhaust pipe, position and hand-tighten the flange nuts and bolts. Fit a new clamp at the connection, ensure alignment and ensure clearances. Fix bolts and check leakages.
• Q:

  How to Remove the Tail Pipe on 2009 Dodge Durango?

  A:

  To remove the exhaust tailpipe, lift the vehicle and spray Mopar(R) Rust Penetrant on the bolts. Remove the exhaust pipe-to-muffler clamp and grind off any tack welds. Remove the exhaust pipe insulators and if necessary heat up the connection to twist in the tail pipe. Always wear protective eyewear.
• Q:

  What's the Best Way to Install a Muffler on 2009 Dodge Durango?

  A:

  To do the muffler installation, replace the band clamps and fix it to the catalytic converter or exhaust pipe in proper alignment. Install new exhaust clamps, muffler isolators keeping 42mm gap. Tighten clamps to 61 Nm. Check for contact with body panels; and check for exhaust leaks.