2009 Dodge Nitro Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Catalytic Converter, Exhaust Pipe, Muffler Installation and Repair Tips for 2009 Dodge Nitro

• Q:

  How to Safely Remove an Exhaust Pipe on 2009 Dodge Nitro?

  A:

  In order to dismantle the exhaust pipe, it should be cold to prevent burns. Torches around fuel lines should be used with care. Lift the car, use rust penetrant, disconnect oxygen sensors and loosen the nuts. Move the exhaust pipe backwards until it snaps out of the transmission support and then pull it out.
• Q:

  How to Service and Repair a Muffler on 2009 Dodge Nitro?

  A:

  In order to mend the muffler, put the car on a hoist. Take off the 2 clamp nuts which tie the exhaust pipe and tail pipe. With the help of a pry bar, loosen and remove the muffler and tailpipe assembly of the exhaust hanger and remove it out of the car.
• Q:

  How to Maintain a Catalytic Converter on a 3.7L Engine on 2009 Dodge Nitro?

  A:

  To service the catalytic converter on a 3.7L engine, raise up the vehicle and place heat valve lubricant on the bolts. Disconnect the oxygen sensor, remove the nuts holding the exhaust pipe and catalytic converter, and remove the bolts at the manifold. Finally, lower and take out the assembly from the vehicle.