2009 Dodge Ram 1500 Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2009 Dodge Ram 1500

• Q:

  How to Install a Windshield Washer Fluid Reservoir on 2009 Dodge Ram 1500?

  A:

  To install the windshield washer reservoir, install the reservoir on the Left-hand side of the Front End Module (FEM) carrier. The need to reconnect the FEM wire harness and washer hose, screw the reservoir into place, reattach grille, replace washer fluid, and reattach battery negative cable.
• Q:

  How is a Wiper Motor Installed on 2009 Dodge Ram 1500?

  A:

  To put the wiper motor, align the motor with the wiper linkage module and fix it with the help of three screws at 12.5 Nm. Reconnect the wiring, set the motor to park and start it. Attach the crank arm to it, tighten with a nut at 28 Nm, and put cowl cover and wiper arms in place.
• Q:

  How to Detach a Wiper Arm on 2009 Dodge Ram 1500?

  A:

  To remove the wiper arm, you must lift the arm, which relieves the tension of the spring, and then pry off the plastic nut cap. Remove the securing nut without using battery terminal pullers so as not to damage it. Finally, rock the wiper arm gently to release it from the pivot shaft and extract it.