2009 Dodge Ram 2500 Catalytic Converter, Muffler, Exhaust Pipe, Tail Pipe

Exhaust Pipe, Muffler, Tail Pipe Installation and Repair Tips for 2009 Dodge Ram 2500

• Q:

  How is a Muffler Installed on a 5.7L Engine on 2009 Dodge Ram 2500?

  A:

  To install the muffler on a 5.7L engine, loosely assemble the muffler and clamps in order to obtain alignment. Connect the hangers and tighten the clamps to 54 Nm (40 ft. lbs.). Make sure isolators are seated, there is a 25 mm gap between body parts and there is no exhaust leak after starting the engine.
• Q:

  How to Install a Tail Pipe on a 5.7L Engine on 2009 Dodge Ram 2500?

  A:

  To install the exhaust tail pipe on a 5.7L engine, assembly loosely for alignment, support hangers connection, underbody components clearance. Tighten clamp nuts to 54Nm (40 ft. lbs.) and check for a minimum 25mm (1.0 in.) clearance. Finally, check for exhaust leaks.
• Q:

  How to Detach the Exhaust Pipe from a 5.7L Engine on 2009 Dodge Ram 2500?

  A:

  To remove the exhaust pipe from a 5.7L engine, raise and pad the vehicle first. Apply heat valve lubricant to the bolts and nuts and allow it to stand for 5 minutes. Then, take off the bolts and nuts that connect the exhaust pipe and the manifold, as well as the clamp nuts, and then take the exhaust pipe off.