2010 Dodge Avenger Wiper Motor, Windshield Wiper, Windshield Washer Fluid Reservoir, Wiper Arm

Windshield Washer Fluid Reservoir, Wiper Arm, Wiper Motor Installation and Repair Tips for 2010 Dodge Avenger

• Q:

  How to Remove the Windshield Washer Fluid Reservoir on 2010 Dodge Avenger?

  A:

  To get rid of the windshield washer reservoir, disconnect the battery negative cable and the washer fluid hose. Partially remove the bumper fascia for access, disconnect the pump wire and mounting tab, remove the two mounting bolts, lower the reservoir and drain the fluid into a container.
• Q:

  How to Detach a Wiper Arm on 2010 Dodge Avenger?

  A:

  To remove the wiper arm, begin by setting the wiper arm/blades in the PARK setting and switching off the ignition. Unsnap the nut cover then loosen and remove the retention nut. Finally, use a universal claw puller to separate the arm from the pivot and lift the arm off.
• Q:

  How to Maintain a Wiper Motor on 2010 Dodge Avenger?

  A:

  To service the wiper motor, start by disconnecting the negative battery cable. Then, remove the wiper module by removing the wiper arm linkage. Use a pry bar to gently try to lift the linkage from the motor crank arm ball stud. Finally, remove the three bolts holding the wiper module and remove the motor.