2010 Dodge Caliber Camshaft, Timing Chain, Timing Cover, Cam Gear

Cam Gear, Camshaft, Timing Chain, Timing Cover Installation and Repair Tips for 2010 Dodge Caliber

• Q:

  How to Ensure Proper Installation and Alignment of a Camshaft on 2010 Dodge Caliber?

  A:

  To install the camshaft, make sure the front bearing cap are correctly numbered, apply oil to the journals and install cam phasers. Align timing marks on sprockets and position camshafts; Tighten bearing caps in sequence, check alignment and install tensioner. Turn the crankshaft, check timing and re-assemble components.
• Q:

  How to Remove a Timing Cover on 2010 Dodge Caliber?

  A:

  To remove the engine timing cover, remove the engine cover, bleed the fuel pressure and disconnect the battery. Remove the coolant bottle, move the power steering reservoir back into place and remove the accessory drive belt. Support the engine, remove a variety of bolts and components, remove the timing chain cover and remove it from the vehicle.
• Q:

  How to Remove and Replace a Timing Chain on 2010 Dodge Caliber?

  A:

  In order to change timing chain, position engine to TDC, position crankshaft and camshaft timing marks, and fit timing chain. Make sure that it is properly aligned and put in tensioner. Turn the crankshaft, ensure it is in place, fit the cover, reattach the battery and make sure the fluids are correct after running the engine.
• Q:

  Can Cam Gear Sprockets and Phasers Be Serviced Independently on 2010 Dodge Caliber?

  A:

  Phasers and camshaft sprockets are an assembly and cannot be serviced independently. When working on camshaft sprocker bolts use of an impact wrench should be avoided, as it may damage the bolts. Install correctly the camshaft phaser, lifters, and push rods and make sure that all the steps are correct.