OEM 2000 Dodge Ram 2500 Van Neutral Safety Switch

2000 Dodge Ram 2500 Van Neutral Safety Switch Parts and Q&A

• Q: How to service the Neutral Safety Switch on a 46RE Automatic Transmission on 2000 Dodge Ram 2500 Van?

  A: Raise the vehicle, then position a drain pan below the Neutral Safety Switch on your 46RE Automatic Transmission. Remove the switch wires from the switch and remove the switch from inside the case. After that, shift the gear into Park and Neutral, then check that the small fingers on the operating levers are positioned in the middle of the switch. Replace the seal over the switch, put the switch into the case and tighten it to 34 Nm (25 ft. lbs.) torque. With the 12V tester, check if the switch is working. Reconnect the wires to the switch and then lower the car. Lastly, make sure the transmission fluid is not low.