How to Maintain a Power Window Switch on 2001 Dodge Ram 3500?

Disconnect the battery negative cable before starting to work on the power window switch. With a trim stick, carefully pull the edge between the upper rim of the switch and the door trim. Take the switch and bezel module out far enough from the opening so you can disconnect the wire harness connector and then pull the unit out of the door trim panel. Before installation, attach the switch to the harness, insert the switch and bezel unit into the gap, push the front of the switch down until the tabs snap and confirm all harnesses are connected. Later on, reconnect the battery negative cable.

OEM 2001 Dodge Ram 3500 Power Window Switch

Electric Window Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Power Window Switch found

View related parts
2001 Dodge Ram 3500 Window Switch Part Number: 56021912AB
Product Specifications
- Other Name: Switch - Window And Door Lock; Door Window Switch; Switch Window And Door Lock 3 Gang; Switch Window And Door Lock
- Item Weight: 0.70 Pounds
- Item Dimensions: 2.7 x 3.1 x 6.1 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 56021912AB
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2001 Dodge Ram 3500 Submodels:
- Base | 10 Cyl 8.0 L GAS, 6 Cyl 5.9 L DIESEL, 8 Cyl 5.9 L GAS

2001 Dodge Ram 3500 Power Window Switch Parts and Q&A

Q: How to Maintain a Power Window Switch on 2001 Dodge Ram 3500?
A: Disconnect the battery negative cable before starting to work on the power window switch. With a trim stick, carefully pull the edge between the upper rim of the switch and the door trim. Take the switch and bezel module out far enough from the opening so you can disconnect the wire harness connector and then pull the unit out of the door trim panel. Before installation, attach the switch to the harness, insert the switch and bezel unit into the gap, push the front of the switch down until the tabs snap and confirm all harnesses are connected. Later on, reconnect the battery negative cable.