How to Remove and Install an Oxygen Sensor in an Engine on 2002 Chrysler 300M?

There are two exhaust manifold and two catalytic converter outlet heat of oxygen sensors on the engine. As an alternative to them, disconnect the battery and replace the sensors with a Snap-On wrench and clean the threads, use anti-seize if reusing, and tighten them to 28 Nm. Refit all this afterwards.

OEM 2002 Chrysler 300M Oxygen Sensor

Oxygen O2 Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

2 Oxygen Sensors found

View related parts
2002 Chrysler 300M Oxygen Sensor, Front Part Number: 4606133AD
$91.13 MSRP: $191.00
You Save: $99.87 (53%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Sensor - Oxygen; Oxygen Sensor, Front, Rear; Rear Oxygen Sensor; Front Oxygen Sensor; Sensor Oxygen
- Position: Front
- Item Weight: 0.60 Pounds
- Item Dimensions: 1.3 x 28.5 x 6.8 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4606133AD
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2002 Chrysler 300M Submodels:
- Base, Pro-Am, Special | 6 Cyl 3.5 L GAS
View related parts
2002 Chrysler 300M Oxygen Sensor Part Number: 4606555AA
Product Specifications
- Other Name: Sensor - Oxygen; Front Oxygen Sensor; Sensor Oxygen
- Item Weight: 5.60 Pounds
- Item Dimensions: 7.2 x 5.3 x 0.5 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 4606555AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
More Info
Fits the following 2002 Chrysler 300M Submodels:
- Base, Pro-Am, Special | 6 Cyl 3.5 L GAS

2002 Chrysler 300M Oxygen Sensor Parts and Q&A

Q: How to Remove and Install an Oxygen Sensor in an Engine on 2002 Chrysler 300M?
A: There are two exhaust manifold and two catalytic converter outlet heat of oxygen sensors on the engine. As an alternative to them, disconnect the battery and replace the sensors with a Snap-On wrench and clean the threads, use anti-seize if reusing, and tighten them to 28 Nm. Refit all this afterwards.