How to Address Worn or Damaged Flywheel Teeth on 2002 Dodge Ram 3500?

If the teeth on the flywheel are worn, change the flywheel assembly. If not available, install a replacement ring gear for V10/Diesel Engines. Mark the location of the old gear, cut the old gear off, and heat the new gear up to 375 degrees F. for installation. Use protective gear and cool it naturally before installing the engine.

OEM 2002 Dodge Ram 3500 Flywheel

Clutch Flywheel

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

3 Flywheels found

View related parts
2002 Dodge Ram 3500 Flywheel Part Number: 53020585
Product Specifications
- Item Weight: 37.80 Pounds
- Item Dimensions: 16.2 x 15.7 x 2.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 53020585
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2002 Dodge Ram 3500 Submodels:
- Base | 8 Cyl 5.9 L GAS
View related parts
2002 Dodge Ram 3500 Flywheel Part Number: 53006216AC
Product Specifications
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 53006216AC
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2002 Dodge Ram 3500 Submodels:
- Base, Laramie, SLT, ST | 10 Cyl 8.0 L GAS
View related parts
2002 Dodge Ram 3500 Flywheel Part Number: 5015624AA
Product Specifications
- Item Weight: 66.70 Pounds
- Item Dimensions: 23.8 x 23.5 x 6.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 5015624AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following 2002 Dodge Ram 3500 Submodels:
- Base, Laramie, SLT, ST | 6 Cyl 5.9 L DIESEL

2002 Dodge Ram 3500 Flywheel Parts and Q&A

Q: How to Address Worn or Damaged Flywheel Teeth on 2002 Dodge Ram 3500?
A: If the teeth on the flywheel are worn, change the flywheel assembly. If not available, install a replacement ring gear for V10/Diesel Engines. Mark the location of the old gear, cut the old gear off, and heat the new gear up to 375 degrees F. for installation. Use protective gear and cool it naturally before installing the engine.